SuperPar HYDROGEN PEROXIDE CLEANER

SUPERPAR may be used on most construction materials including treated and untreated lumber, OSB, particle board, masonry surfaces, concrete, brick, wall board, painted surfaces and composite construction materials. Surfaces also include sheathing, trusses, framing, joists, plates, pillars, posts, beams and studs.

SuperPar is compatible with all Enviroguard products including other Cleaners & Stain Removers, Disinfectants & Deodorizers, Coatings and Sealants and Enviroguard Equipment.

SuperPar will yield 150-400 ft2 per ready-to-use gallon, based upon soil level, surface texture, porosity and application method. Coverage rates do not include loss from over-spray or over-use.

• Apply to the point of saturation and/or run-off
• Contaminants will be identified on the surface within 10-15 seconds.
• Allow the oxidative reactions to drive soil load into the resultant foam until saturated.
• Remove soiled foam from surface by wipe or extraction methods.
• Re-apply as needed.
• Allow to dry.

• Eye & Respiratory Protection: Full Face Respirator w/ Multi-gas/Multi-vapor Combination Cartridge or Supplied Air Respirator w/ PAPR Cartridge
• Skin Protection: Chemical Resistant Gloves (Nitrile) and Coverall rated for a minimum of 4 hours and up to 8 hours based upon prolonged chemical exposure and the need for tear resistance
• Consult SDS for additional safety details

For unused product, return to original container making sure to not cross contaminate with other chemicals. If spilled, contain material and remove with an inert absorbent. Sweep up and dispose of material.
Dispose of used product per all current federal, state and local regulations.